More ideas from Nazif
The engineer who made this is unknown as I bought this from Myford, who in turn bought it and other machines and tooling from the engineers estate. The VDH is made to Geo. H. Thomas design, and was made to suit the Myford 10 range of lathes. For my uses on a Super 7, I made a spacer plate to obtain correct centre height. Unfortunately due to circumstances this is another item I had to sell.

The engineer who made this is unknown as I bought this from Myford, who in turn bought it and other machines and tooling from the engineers estate. The VDH is made to Geo. H. Thomas design, and was made to suit the Myford 10 range of lathes. For my uses on a Super 7, I made a spacer plate to obtain correct centre height. Unfortunately due to circumstances this is another item I had to sell.

Rorty Roll Bender www.rorty.net

Rorty Roll Bender www.rorty.net

DIY Utilli-trac Tie Down Points - Nissan Frontier Forum

Last week I was trying to figure out a way to make some semi-permanent mounting points for the utili-trac. This mod is

The Ultimate Rack ATV Truck Rack

Load up to two ATVs on to the truck rack with supplied 12 foot long aluminum ramps for quick and easy transportation of two quads